RCHeliguy
Premium
Here is the 3D printed part with threaded inserts already melted into place.
I used 2 inserts and 2 locknuts to bolt the collective stick to the mount.
Then two M8 knobs into t-nuts to hold it in place.
It also braces against the vertical slot.
The knobs could be a bit shorter, but this works.
And of course a bolt fixed to the frame to make sure that I get identical placement every time I bolt it up.
I used 2 inserts and 2 locknuts to bolt the collective stick to the mount.
Then two M8 knobs into t-nuts to hold it in place.
It also braces against the vertical slot.
The knobs could be a bit shorter, but this works.
And of course a bolt fixed to the frame to make sure that I get identical placement every time I bolt it up.
Virpil Collective Stick 40 series profile mount by RCHeliGuy
This is a mount for the Virpil collective stick to the side frame of a profile rig.It uses two M8 knobs to hold the 3D printed part to the rig.It uses two M5 bolts into locknuts and two M5 bolts into threaded inserts.
www.thingiverse.com
Last edited: