I hope this haven't been asked before but the brake bias MFD logic is swapped (I'm using CSP ver. 0.1.80-preview428) as shown here below :
If the intention is to make sure the up and down buttons to actually fits the logic of increasing and decreasing the onboard setup (in this case the brake bias, other MFD controls work just fine), I think these words should've been swapped too, no?
Sorry if this seems like a minor nitpicking but I do also use visual cues on how my car being set up so this being inverted actually kinda screwed me a bit when driving.
If the intention is to make sure the up and down buttons to actually fits the logic of increasing and decreasing the onboard setup (in this case the brake bias, other MFD controls work just fine), I think these words should've been swapped too, no?
Sorry if this seems like a minor nitpicking but I do also use visual cues on how my car being set up so this being inverted actually kinda screwed me a bit when driving.