SFX-100 questions

[Elaphe]

How much is a SFX-100? I mean, what is the aproximate cost for having it completelly operational on your rig?
Also, how much weight can it bear? My rig is already very heavy, to which I would have to add my own weight.

 

[Mehmet Baran]

Hi everyone,

I am having some troubles in getting the ST motors to my country because of high taxes and shipping costs. It becomes so expensive that i have started to look for a solution inside the country.

So I have found these motors and drives:

1- ASD-B2-0721-B - Servo drive : https://www.damencnc.com/en/ac-servo-drive-750w-asd-b2-0721-b/a806

2 - ECMA-C20807RS - AC Servo Motor 750W 17 Bit 3000rpm Frensiz 2.39 Nm, 80mm flanş, 19mm şaft. :
https://www.damencnc.com/en/ac-servo-motor-750w-ecma-c20807rs/a815

Will these work? I will probably adjust the 3d printings if necessary.

Will simfeedback firmware work?

If not, what should i look for when i ask for a suitable motor to the manufacturers?

Thank you.

 

[Pablo Roldan]

The seat should be centered on the 4 actuators as much as posible for the proper pitch and roll, right?.

I see a lot of videos of people with the rear actuators at the back of their rigs side by side with the rear of the seat, and the front actuators further up front.

How do you have sfx100 actuators placed?.