Hey all
Been very happy with my SSH shifter, but in the last week or so the input mappings on it are different to usual. For example, button 1 is detected as button 8, button 2 simply doesn't get picked up as an input and 3 and 4 appear to be either end of an axis.
Switching to sequential mode it still works fine.
I thought I may have broken it by installing vjoy (needed it for flight sim stuff), so I uninstalled it and manually removed vjoy.sys from System32/drivers but its still acting the same way.
This happens whether Steam is loaded or not, and I've checked that controller stuff is disabled there anyway.
At a bit of a loss to what to try next.
Been very happy with my SSH shifter, but in the last week or so the input mappings on it are different to usual. For example, button 1 is detected as button 8, button 2 simply doesn't get picked up as an input and 3 and 4 appear to be either end of an axis.
Switching to sequential mode it still works fine.
I thought I may have broken it by installing vjoy (needed it for flight sim stuff), so I uninstalled it and manually removed vjoy.sys from System32/drivers but its still acting the same way.
This happens whether Steam is loaded or not, and I've checked that controller stuff is disabled there anyway.
At a bit of a loss to what to try next.
Last edited: