Note: Testing with the Wheel Check app on my G25 it needed a 10% minimum torque (min force)
Some helpful info i googled:
• Dial in min force setting using "wheel check" or by feel. Google "Iracing wheel check"
(I've tested 4x G27s with "wheel check", results range from 12% to 22%)
The goal is to get the wheel to apply a smooth steady force while turning back and forth through center point. So turn this up till you start to feel a clunk, then dial it back down.
"Min force attempts to correct a flaw (or feature, it is intentionally put there) in some wheels where the wheel will not react to our FFB commands unless the force goes above some minimum amount. This is especially important on a Logitech G27 wheel, those wheels need 10-20% min force in order to get them to react to any force at all. If min force is set too high, then the wheel will chatter when driving straight. So the simplest way to set it is just to try 10% and then 5% or 20% depending on if the wheel chatters or not, going back and forth until you get close enough to a reasonable number. You can also use "Wheel Check" and do some testing to figure out the exact number but being exact isn't crucial.
Some helpful info i googled:
• Dial in min force setting using "wheel check" or by feel. Google "Iracing wheel check"
(I've tested 4x G27s with "wheel check", results range from 12% to 22%)
The goal is to get the wheel to apply a smooth steady force while turning back and forth through center point. So turn this up till you start to feel a clunk, then dial it back down.
"Min force attempts to correct a flaw (or feature, it is intentionally put there) in some wheels where the wheel will not react to our FFB commands unless the force goes above some minimum amount. This is especially important on a Logitech G27 wheel, those wheels need 10-20% min force in order to get them to react to any force at all. If min force is set too high, then the wheel will chatter when driving straight. So the simplest way to set it is just to try 10% and then 5% or 20% depending on if the wheel chatters or not, going back and forth until you get close enough to a reasonable number. You can also use "Wheel Check" and do some testing to figure out the exact number but being exact isn't crucial.
Last edited: