Sell Pro-Race 2 Display & 3D Printed Housing

[ColinMac]

Now Sold thanks

• Gear indicator at the center of the display
• Two 6-digits displays that can be used for lap times (current, best and last lap time), RPM, speed, water/oil temperature and pressure. and more…
• 15 shift light LEDs.
• 6 more LEDs to use as warning indicators (flags, traction control, speed limiter, etc…)
• 20 inputs on the back of the display. Each input can accept a push button, a toggle switch or a rotary switch.
• Each input has its own dedicated pair of pins, making connection much easier compare to the previous version of the Pro-Race.
• The Pro-Race is detected by Windows as a Game Controller. This means the connected push buttons, toggle switches and rotary encoders can be used to control the simulator, like with any other game controller.

I bought it as a bare PCB but have printed a carbon fibre PLA housing and face panel for it. Note that some final work is needed for the PCB support & screwing the faceplate down are needed but just chopping up some plastic and maybe some hot glue will do the job perfectly.

The LEDS are all super bright - much better than a LCD dash for 'out of the corner of your eye' RPM etc, and this might be perfect for someone building a wheel, as it can also take a variety of buttons etc - it has 20 inputs for buttons, paddles, etc.

More info at the website here

£45 + postage from the UK.

 

[MarkModdy]

Just pm’d you…

 

[ColinMac]

Replied fella

 

[MarkModdy]

Paid

 

[ColinMac]

Now sold thanks.