I just got two Buttkicker Advance (one for under my seat and one for under my pedals) and I am running them with a Behringer NX1000D amp. I have a ASUS Xonar DGX sound card outputting to the NX1000D.
The issue I am having is that in Windows 10 I cannot turn the volume up on the card over 50%. It will let me turn it past 50% but Windows immediately sets it back to 50%. I went into the ASUS sound software and tried to turn the volume up there as well and it did the same thing and reverted back to 50%.
So I unplugged the audio cable from the sound card and it let me set the volume to 100% and did not revert back.
Next I tried using my motherboard's onboard audio out to the NX1000D amp and it did the same thing where it only let me set volume to 50% and would revert it back if I tried to set it higher.
in Windows 10 I cannot turn the volume up on the card over 50%. It will let me turn it past 50% but Windows immediately sets it back to 50%. I went into the ASUS Gui and tried to turn the volume up there as well and it did the same thing and reverted back to 50%.
This is the cable I bought to go from my sound card to the NX1000D:
Anyone have any ideas on what I might be doing wrong?
Thanks
The issue I am having is that in Windows 10 I cannot turn the volume up on the card over 50%. It will let me turn it past 50% but Windows immediately sets it back to 50%. I went into the ASUS sound software and tried to turn the volume up there as well and it did the same thing and reverted back to 50%.
So I unplugged the audio cable from the sound card and it let me set the volume to 100% and did not revert back.
Next I tried using my motherboard's onboard audio out to the NX1000D amp and it did the same thing where it only let me set volume to 50% and would revert it back if I tried to set it higher.
in Windows 10 I cannot turn the volume up on the card over 50%. It will let me turn it past 50% but Windows immediately sets it back to 50%. I went into the ASUS Gui and tried to turn the volume up there as well and it did the same thing and reverted back to 50%.
This is the cable I bought to go from my sound card to the NX1000D:
Anyone have any ideas on what I might be doing wrong?
Thanks