Trying to get my ardunio pedals to work
It registers the axis and i can get it to invert by holding the pedal in before i add the axis. So it registers it but shows nothing on the calibration, why? . It did somewhat work under the TS PC RACER preset for one time but never again. it also does not register the full range from my thrustmaster cougar that is an Z axis but moves the Y axis in calibration. It starts at 50%.
Its currently set to Z X Y Axis trough ardunio
Any tips or hacks are welcome but i fear im ****ed. They dont even have mouse support in their oh so good port. Add proper axis detection, woah thats just far to much to ask.
It registers the axis and i can get it to invert by holding the pedal in before i add the axis. So it registers it but shows nothing on the calibration, why? . It did somewhat work under the TS PC RACER preset for one time but never again. it also does not register the full range from my thrustmaster cougar that is an Z axis but moves the Y axis in calibration. It starts at 50%.
Its currently set to Z X Y Axis trough ardunio
Any tips or hacks are welcome but i fear im ****ed. They dont even have mouse support in their oh so good port. Add proper axis detection, woah thats just far to much to ask.
![Luca [OT]](https://overtake-data.community.forum/avatars/s/3235/3235113.jpg?1697196734){kind=avatar}
